Epoxy resin, zinc, anti-rust pigments, additives, solvents and other supporting component and two-component curing agent anti-rust primer. Key Features: * Excellent high barrier properties, rust resistance. * Excellent adhesion on sandblasted steel. * Good water resistance, oil resistance and solvent resistance. * Drying fast, has good workability. * There is cathodic protection. Uses: * For coating steel surface corrosion and rust. Color and Appearance: * Grey, film appearance is normal. Basic parameters: * Weight: about 2.10kg / L (mixed) * ratio: Part A (paint): Part B (curing agent) = 10: 1 (mass ratio) * Dry film thickness: about 40um * Theory Dosage: about 110g / m2 (with 40um dry film meter, excluding losses) * Flashpoint: approximately 29oC * Drying time: dry ≤1h, hard work ≤24h, completely dry 7d * Curing time: 0.5h (23 ℃ ± 2 ℃) * Applicable period: ≤8h (23 ℃ ± 2 ℃) recoat time: Substrate temperature 5 ℃ 20 ℃ 30 ℃ Shortest 48h 24h 12h 7d 7d 7d longest Suggested painting number: * Airless 1 , brushing or roller coating 1-2 Road. Former word matching: * Direct coating in rust on the steel surface quality to meet Sa2.5 level, or coating in epoxy paint surface can be welded. Road after supporting: * epoxy micaceous iron oxide paint, epoxy paint, chlorinated rubber paint, epoxy asphalt paint, acrylic polyurethane paint, polyurethane paint, chlorosulfonated paint, fluorocarbon, alkyd. Finish: * steel surface sandblasted to Sa2.5 level, surface roughness 30um-75um. * Electrical tools rust achieve St3. Construction conditions: * Substrate temperature must be above 3 ℃, relative humidity must be less than 85%. * When the coated substrate temperature below 5 ℃, the curing reaction of epoxy resin and a curing agent to stop or slow down, it is recommended not for construction. Coating Application: * Mixed: This product is divided into two containers as a unit. Each must be specified ratio, one-time mixing, stir and mix in the prescribed time limit runs out. * Airless: Thinner: epoxy special thinner. Diluting status: 0-5% (in the paint weight) Nozzle diameter: 0.4mm-0.5mm discharge pressure: 20MPa-25MPa (200kg / cm2-250kg / cm2) * air spray: Thinner: epoxy special thinner . Diluting: 10-15% (in the paint weight) Nozzle diameter: 1.5mm-2.0mm discharge pressure: 0.3MPa-0.4MPa (3kg / cm2-4kg / cm2) * Roller: Thinner: Epoxy series dedicated diluent amount: 5-10% (by weight paint ratio) * Cleaning: epoxy special thinner NOTES: * This product is the same as with most zinc-rich paint, zinc salts of long-term exposure to the film will appear in the coating It must be thoroughly cleaned before the next painting, otherwise it will affect the adhesion between the layers. * When high temperature seasons, prone to dry spray, in order to avoid dry spray thinner to adjust to quit spray available so far. * This product should be professional applicators in accordance with the instructions on the product packaging or use of this manual. * The application and use of this product all work must be carried out according to various national health, safety and environmental regulations and standards related. * If you have questions about whether to use this product, please contact our technical service department for details. Packaging: * Part A (paint): 30kg barrel * Part B (hardener): 3kg drum storage:? * Store in a dry place, avoid sun exposure, the effective storage 12 months, more than storage period? passing inspection can still be used.